WHEEL SETS REPAIR 2018-11-30T12:29:42+00:00

WHEEL SETS REPAIR

Our company conducts intermediate and complete checkup of wheel tread with turning and without it, a complete checkup of wheel thread with overlaying welding and turning.

Wheel set consists of axle, all-rolled wheels, axial gear, labyrinth seals of bearings and cups whereon axial gear box is mounted. Diameter of wheel rolling circle is 1050 mm. Wheels and gears are fitted by thermal method. Wheel set axle is made of OSL steel, neck surfaces, wheel seat and section before wheel seat are burnished with rollers at 2500 kg load per roller, thereafter these surfaces are polished. Roller burnishing several times increases necks fatigue strength and reduces its wear at repressions of bearings. On one side of the axle there is a drilling whereto square hole sleeve is pressed under speedometer drive shank. The sleeve is made of steel and heat treated to hardness in order to avoid rapid wear of square hole.

OUR COMPANY PERFORM THE FOLLOWING REPAIR WORKS OF WHEEL SETS:

  • Dismounting and installation of wheel sets (repair as prescribed in ВНД 32.0.07.001-2001 with revision №1);
  • Dismounting and installing of roller axle box for wheel sets, complete inspection, repair (according to PP 105.80700.11693);
  • Replacement of silent blocks;
  • Dismounting and installation of roller bearings. Diagnostics, flaw detection (if defective parameters are found — replacement).

OUR COMPANY PERFORM THE FOLLOWING REPAIR WORKS OF BRAKE SYSTEMS:

  • Repair and testing of handbrake system;
  • Compressor repair and running-in;
  • Repair and testing of air tanks;
  • Repair and testing of brake lever gear;
  • Repair and testing of brake cylinders;
  • Repair and installation of sandboxes;
  • Repair and installation of driver’s brake valve (conv. No. 394);
  • Repair and installation of driver’s auxiliary brake valve (conv. No. 254);
  • Repair or replacement of brake valves;
  • Repair and installation of air distributors.